![background image](http://html1.mh-extra.com/html/gardner-denver/welch-lvs-105-t-10-ef/welch-lvs-105-t-10-ef_operation-manual_3569511030.webp)
Set-up and connection
30
Operation Manual LVS 105 T
– 10 ef
+
5
Set-up and connection
5.1 Unpacking
ATTENTION
►
The General Terms and Conditions of the manufacturer apply.
►
The scope of delivery is determined by the delivery contract!
►
Keep the packaging in case the device needs to be sent back to the man-
ufacturer's factory or an authorized workshop for repair.
Unpack the device carefully. Check for:
Transport damage
Matching with the specifications of the delivery contract
Completeness of the delivery
Inform us immediately if there are differences from the contractually agreed-upon scope of
delivery or damage!
5.2 Set-up
ATTENTION
►
Heed the safety instructions.
►
When setting up the device, make sure that the distance to adjacent sur-
faces is at least 5 cm.
►
Provide for adequate ventilation.
Place the device on a flat and horizontal surface.
5.3 Connection
ATTENTION
►
Heed the safety instructions.
►
Use only pre-assembled lines from the manufacturer. This prevents in-
correct connections.
►
Route all vacuum connecting lines with short distances and a large nom-
inal width to prevent pumping speed losses.
Avoid rigid connections.
►
Mount the vacuum connecting lines carefully to achieve a low leakage
rate.
►
Check the vacuum lines and vacuum connections of the entire system
for any leakage before beginning work.
Procedure
1. Remove the protective caps on the connectors.
2. Connect the intake connector of the device with your vacuum application via a vacuum
hose DN 8.
3. Connect the cooling water line to the emission condenser.
4. Connect the cooling water outlet without pressure.
5. Connect the exhaust with the central exhaust system.