13-17-621 Page 36
3. The
View Schematic
button is used to navigate to the Schematic screen. This provides a graphical
representation of the machine operation and status.
4. The Control Settings Indicators area of the screen shows the current status of the control settings
that control the machine operation and starting / stopping of the machine. Pressing anywhere within
this area of the screen will navigate to the Control Settings screen which can be used to adjust
these settings.
o
Remote Halt
: The Remote Halt indicator reflects the setting of Remote Halt Mode on the
control settings screen. If the Remote Halt Mode is Disabled, the indicator will show Off. If
the remote halt mode is Timed or Immediate, the indicator will show On.
o
Timer Control
: The Timer Control indicator reflects the setting of Timer Start Enable on
the Control Settings screen.
o
Auto Restart
: The Auto Restart indicator reflects the setting of Auto Restart Enable on the
Control Settings screen.
5. The Status Message Bar displays information about the current machine status. If a fault or warning
is active, red or yellow attention indicators will illuminate on the bar.
6. The
View Hours
button links to the Service Dashboard screen, which can be used to view,
configure, and reset all of the maintenance timers on the system
7. The Total / Loaded hours display shows the current total and loaded hours of the machine.
8. The Hours Left to Service bar graph indicates the value of the minimum service timer. The colors
and fill of the graph change to give a visual indication of the length of time until next service as
described below:
o
100% service life, timers just reset:
o
Service life greater than 350 hours:
o
Service life of 350 hours or less:
o
Service life of 175 hours or less:
3.2.1 Screen Saver
After the controller has been sitting idle without any human interaction for 10 minutes a screen saver will
show on the display like in Figure 44 below. This page shows the current status of the machine and
important information is displayed in large text so a tech can view it from a distance away from the
machine. Here the delivery pressure and the discharge temperature is shown. It can be seen that the
machine is currently enabled and ready to be started in the first image and running and loaded in the
second image. To exit the screen saver and return to the home screen, touch anywhere on the screen.
