Gardner Denver Elmo Rietschle V-VTE Series, Operating Instructions Manual

Page: 50 / 52

24 |
www.gd-elmorietschle.com © Gardner Denver Schopfheim GmbH, Gardner Denver Deutschland GmbH
Malfunctions: Causes and elimination
8 Malfunctions: Causes and elimination
Fault Cause Troubleshooting Important
Machine is
switched off by
the motor pro-
tection switch Mains voltage/ Frequency
does not correspond with
the motor data Check by qualified electrician Section 5.5
Connection to motor termi-
nal board is not correct
Motor protection switch is
not set correctly
Motor protection switch is
triggered too quickly Use a motor protection switch with an
overload-dependent delayed switch
off that takes into consideration the
short term excess current at start up
(version with short circuit and overload
trigger as per VDE 0660 Part 102 or
IEC/EN 60947-4-1)
Pumping ca-
pacity is insuf-
ficient The intake filter is dirty Clean or replace the intake filter Section 7.2.1
Section 7.4
The suction pipe is too long
or too narrow Check the hose or the pipe Section 5.3
Machine or system leaking Check the pipework and screw con-
nections for leaks and to ensure that
they are firmly seated. Section 7.2
Blades are damaged Replace blades Section 7.2.2
Section 7.4
Final pressure
(max. vacuum)
is not reached Machine or system leaking Check the pipework and screw con-
nections for leaks and to ensure that
they are firmly seated. Section 7.2
Blades are worn or damaged Replace blades Section 7.2.2
Section 7.4
Machine gets
too hot Ambient or intake tempera-
ture is too high Ensure it is being used properly Section 2.3
Cooling air supply is ob-
structed Check environmental conditions Section 5.1
Clean ventilation slots Section 7.2
The machine
makes an ab-
normal noise The compressor housing is
worn (chatter marks) Repair by manufacturer or authorised
workshop Elmo Rietschle
Service
The vacuum regulating valve
(if fitted) is vibrating Replace the valve Section 7.4
Blades are damaged Replace blades Section 7.2.2
Section 7.4
Please contact Elmo Rietschle Service for other malfunctions or those that cannot be eliminated.
Tel. 071 918 60 60, Fax 071 918 60 40 Mail: v-g@prematic.ch www.prematic.ch