13–8–612 Page 37
SYMPTOM
POSSIBLE CAUSE
REMEDY
Erroneous Pressure Readings
1.
Electrical noise creating
1.
Make sure transducer wires
[135 – 150 psig constantly].
false readings.
are kept to a minimum length
(9.3 – 10.3 Bars)
and are twisted.
2.
Loose connector.
2.
Measure the DC voltage
between the green and black
wires of the corresponding
transducer at the control
board with zero pressure on
the transducer. If .460 to
.540 volts, replace the plug–
gable connector that con–
nects transducers to the
board.
3.
Bad transducer.
3.
Measure the DC voltage
between the green and black
wires of the corresponding
transducer at the control
board with zero pressure on
the transducer. If below .450
or over .550 volts, replace the
transducer.
Oil leak at the bottom of
1.
Gasket leaking.
1.
Replace the gasket.
the seal housing.
2.
Plug leak.
2.
Repair.
3.
Capscrew leaking.
3.
Repair.
4.
Shaft seal leaking.
4.
Change seal.
Fuse on board blows.
1.
Board damaged by
1.
Remove all power from the
high voltage.
unit by opening the main
disconnect, replace fuse,
energize main power. If fuse
blows – replace board.
Fuse on transformer blows.
1.
Shorted coils on hour
1.
If fuse does not blow, check
meter, starter coil,
for shorted coils.
or blowdown valve.
Gardner Denver factory remanufactured replacement compressor air end units
are available from your authorized distributor, on an exchange basis, for all rotary
screw compressor units.
Summary of Contents for EBB BB-7.5 HP
