Control
Functions
Oscillation angle dial
3
Use this to set the desired angle of the oscillation.
Function control dial
4
Use the function control dial to set one of the functions
listed below:
Oscillation HIGH
5
Oscillation at high heating output
Oscillation LOW
6
Oscillation at low heating output
OFF
9
The device is switched off
LOW
7
Low heating output
HIGH
8
High heating output
Carry handle
10
Use the carry handle to transport the device.
Turning the device on and off
The device
1
features a tilt
protection switch
11
. This switches
the device off automatically as soon as
it tilted or lifted.
Operation continues once the device
has been positioned correctly again.
1. Turn the function control dial
4
so that it points to the desired function option.
The device starts performing the respective function option.
2. To switch the device off, turn the function control dial to the OFF
9
position.
Overheating protection
The device has an overheating protection. This switches the device off
automatically as soon as the device reaches an unsafe level. This is a protective
measure.
1. Disconnect the device from the power supply.
2. Turn the function control dial
4
so that it points to the OFF
9
position.
3. Wait for about 5 minutes until the temperature cools down.
4. Connect the device to the power supply.
5. Switch the device on (see section "Turning the device on and off").
C
11
Operation
14
