1198V Rev 11/18
#8597445
Nocturne Obelisk 6’
This Obelisk makes a striking statement with its aged
bronze finish on the outside and brass foil finish on the
inside. It's perfect for supporting your favorite annual and
perennial vines.
Parts List
Tools needed
(1) Top Section
Phillips Screwdriver
(3) Tier
Rubber Mallet
(3) Rings
(3) Bolts
(3) Cap Nuts
(4) Stakes
Assembly
NOTE:
Assembly is easiest with two people.
Step 1.
We recommend assembling your Obelisk where
you intend to install it. Select a location that is protected
from high winds and is away from children’s play
areas.
NOTE:
The Obelisk must be installed in firm
soil. If you have loose or sandy soil, we recommend
securing it in concrete.
Step 2.
Place a Tier in your chosen spot and press the
hollow ends into the ground to mark their
locations. Move the Tier to the side and
use your rubber mallet to gently pound
the Stakes into the marked spots. Slide the
hollow ends of the Tier over the tops of the
Stakes.
Step 3.
Slide the loops inside of a Ring over
the pronged ends of the Tier from Step 2.
Slide the loose end of the ribbon under the
Ring, lining up the holes in the ribbon and
the nearest upright. (Figure 2). Place a Bolt
through the set of holes and screw a Cap
Nut onto the end of it.
over please
Stakes
Tier
Ring
Top Section
Tier
Ring
Tier
Ring
Figure 1
Ring
ribbon
upright
with hole
Bolt
Cap Nut
Tier
Figure 2
