0944V Rev 12/16
#8594274
Galvanized Elevated Raised Bed
The Galvanized Elevated Raised Bed offers the comfort of waist-high gardening with a sleek, modern look. It is built to last, easy to
use, and the self-watering reservoir ensures your plants will get all the water they need, while cutting down on your watering chores.
It's perfect for growing vegetables or creating dramatic flower displays.
Parts List
(2) Side Panels
(8) Bolts
(2) End Panels
(8) Small Screws
(4) Legs
(24) Medium Screws
(4) Leg Caps
(8) Large Screws
(4) Platform Supports
(1) Floor Support
Tools Required
(2) Reservoir Bases
Phillips screwdriver
(2) Reservoir Tops
Rubber mallet
(18) Capillary Tubes
(2) Drainage Plugs
(2) Fill Tubes and Water Level Indicators
(4) Wheels (2 with brakes, 2 without)
Assembly
Caution:
Metal edges may be sharp. Please be careful when assembling your planter.
NOTE:
Assembly is easiest with two people.
Step 1.
Identify and organize all the parts on a clean, level surface.
NOTE:
Please notice how there are two styles of Platform Supports
that are mirror images of each other.
Step 2.
Examine a Leg and notice how there are two predrilled holes near the bottom of the slots (Figure 1). Take a Platform Support
and line up the holes on it with the holes on the Leg, as shown in Figure 1.
NOTE:
If you are unable to line up the holes, try the
other style of Platform Support. Place Medium Screws through both sets of lined up holes and tighten them into place using a
Phillips screwdriver. Repeat to attach the remaining Platform Supports to the other three Legs.
Step 3.
Attach a Side Panel to a Leg by placing the plastic knobs into the openings on the Leg and sliding the Panel down until it sits
on the bottom of the slot (Figure 2).
Important:
Attach the Side Panel to the slot where the Platform Support will sit against the
Panel.
NOTE:
You may need to use a rubber mallet to tap the Panel into place. Place a Small Screw into the hole at the top of the
slot to help keep the Panel in place. Repeat to attach a Leg to the other end of the same
Side Panel.
Step 4.
Repeat Step 3 to attach Legs to the remaining Side Panel.
Step 5.
Insert the plastic knobs on the End Panels into the
remaining slots on the Legs to form a rectangle. Pull
down on the Panels to make sure they are sitting at
the bottom of the slots, and insert Small Screws into
the holes at the top of the
Legs (Figure 2).
over please
_
Figure 1
Platform
Support
Leg
slots
holes
Floor Support
Side Panel
End
Panel
Legs
Platform
Supports
Figure 3
Side Panel
Leg
screw
Platform
Support
Figure 2
knob
