Message
Cause
Action
Mowing limited by
SensorControl
The mowing time is limited by the Sen-
sorControl function. The SensorControl
automatically adapts mowing time to
the lawn growth rate.
This behavior is normal and no action
is required, unless the lawn looks un-
cut. Then increase the intensity level of
the SensorControl, or temporarily
switch it off.
6.4 Indicator lamp in the charging
station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing
green light. If something else appears, follow the troubleshooting guide below.
There is more help on www.gardena.com. If you still need help, please contact your local GARDENA
representative.
Light
Cause
Action
Solid green light
Good signals
No action required
Green flashing
light
The signals are good and
ECO mode is
activated.
No action required.
Blue flashing light The boundary loop is not connected to
the charging station.
Check that the boundary wire connec-
tors are fitted properly to the charging
station.
Break in the boundary loop.
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire, and splice using an orig-
inal coupler.
Red flashing light
Interruption in the charging station’s an-
tenna.
Contact your local GARDENA repre-
sentative.
Solid red light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
Contact your local GARDENA repre-
sentative.
1025 - 001 - 23.01.2019
Troubleshooting - 41
