Gardena SILENO+ Series, Operator'S Manual

Page: 23 / 52

3.10.2.4 To reset the timer setting
You can remove all timer settings and use the
factory setting. The factory timer setting lets the
product to operate all hours of each day of the
week. Refer to
Timer and Standby on page 29.
1. Do steps 1–3 in To get access to the menu
on page 22.
2. Use the arrow buttons and the OK button to
move through the menu structure
Timer >
Overview Timer settings > Overview > Reset
timer.
a) Push the arrow buttons to select
Current day to only set the current day
to factory settings.
b) Push the arrow buttons to select
All
week to reset all timer settings to
factory settings.
3. Push the OK button.
3.10.3 Security level
There are 3 security levels for the product.
Function Low Medium High
Alarm X
PIN-code X X
Time lock X X X
• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
3.10.3.1 To set the security level
Select 1 of 3 security levels for your product.
1. Do steps 1–3 in
To get access to the menu
on page 22.
2. Use the arrow buttons and the OK button to
move through the menu structure Settings >
Security > Security level.
3. Use the arrow buttons and the OK button to
select the level of security.
4. Push the OK button.
3.10.3.2 To change the PIN-code
1. Do steps 1–3 in
To get access to the menu
on page 22.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Security > Advanced > Change PIN-code.
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3.
3.10.4 SensorControl
The SensorControl automatically adjust the
cutting time to the growth of the grass. The
product is not permitted to operate more than the
timer settings.
The first operation of the day is set by the timer
settings. The product always complete 1 mowing
cycle, and then the SensorControl selects if the
product will continue to operate or not.
Note: The SensorControl is reset if the product
does not operate for more than 50 hours, or if a
reset of all user settings is done. The
SensorControl is not changed if a reset of timer
settings is done.
1025 - 001 - 23.01.2019 Installation - 23