![Gardena SILENO+ R160Li Operator'S Manual Download Page 29](http://html1.mh-extra.com/html/gardena/sileno-r160li/sileno-r160li_operators-manual_562724029.webp)
20 in. and then stop. This indicates that it is
charged and ready to start mowing.
Note: It is recommended to change the operation
selection to
Main area before placing the product
in the charging station.
4.3.3 Override timer
The timer settings can be temporarily overridden
by selecting
Override timer. It is possible to
override the timer for 24 h or 3 days.
4.3.4 Spot cutting
Spot cutting is useful for quickly mowing an area
where the grass has been mown less than in
other parts of the garden. You must manually
move the product to the chosen area.
Spot cutting means that the product mows in a
spiral pattern in order to cut the grass in the area
where it was started. When this is done, the
product automatically switches back to
Main area
or
Secondary area.
The
Spot cutting function is activated with the
START button. You can select how the product
should continue to work once mowing is finished
by pressing the OK button and then specifying
On Main area or On Secondary area.
4.4 Operating mode Park
When the PARK button is pressed the following
operation selections can be chosen.
4.4.1 Park until further notice
The product stays in the charging station until
another operating mode is selected by pressing
the START button.
4.4.2 Start on next timer
The product stays in the charging station until the
next Timer setting permits operation. This
operation selection is suitable if one wishes to
cancel an ongoing mowing cycle and allow the
product to stay in the charging station until the
next day.
4.5 Stop
1. Press the STOP button on top of the
product.
The product stops and the blade motor stops.
4.6 Switch off
1. Press the STOP button on top of the
product.
2. Set the Main switch to position
0.
WARNING: Always switch off the
product using the main switch if it
requires maintenance, or if the product
must be moved outside the work area.
4.7 Timer and Standby
The product has an inbuilt standby period
according to the Standby time table. The standby
period provides for instance a good opportunity to
water or play games on the lawn.
Model
Standby time, minimum
hours per day
R160Li, R160LiC 1
The factory settings for the timer allow the
product to operate around the clock 7 days a
week. However, the product will not operate
during the built-in standby period.
4.7.1 Example 1
The times used in this example are applicable to
R160Li, but the principle is the same for other
models.
Timer setting,
Period 1: 00:00-24:00
Active period (A): 00:00-23:00
The factory setting ensures that the product
begins cutting the lawn at 00:00. However the
product is parked in standby mode in the
1025 - 001 - 23.01.2019
Operation - 29