Symptoms
Cause
Action
Uneven mowing re-
sults.
The robotic lawnmower works too few hours
per day.
pagina 24.
The shape of the working area requires the
use of
Area 1-3 for the robotic lawnmower to
find its way to all remote areas.
Use
Area 1-3 to steer the robotic lawnmower
Lawn coverage op pa-
gina 28.
The
How often? setting is incorrect in relation
to the layout of the working area.
Check that the correct
How often? value is
selected.
Working area too large.
Try limiting the working area or extending the
Dull blades.
Replace all the blades. See
gen op pagina 41.
Long grass in relation to the set cutting
height.
Increase the cutting height and then succes-
sively lower it.
Accumulation of grass by the blade disc or
around the motor shaft.
Check that the blade disc rotates freely and
easily. If not, screw off the blade disc and re-
move grass and foreign objects. See
the robotic lawnmower op pagina 40.
6.6 Find breaks in the loop wire
Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such as when
gardening with a shovel. In countries with ground frost,
also sharp stones that move in the ground can damage
the wire. Breaks can also occur due to the wire being
stretched excessively during installation.
Mowing the grass too low right after the installation can
damage wire insulation. Damage to the insulation may
not cause disruptions until several weeks or months
later. To avoid this, always select the maximum cutting
height the first weeks after installation and then lower
the height one step at a time every second week until
the desired cutting height has been reached.
A defective splicing of the loop wire can also lead to
disruptions several weeks after the splice was done. A
faulty splice can, for example, be the result of the
original coupler not being pressed together hard enough
with a pair of pliers, or that a coupler of lower quality
than the original coupler has been used. Please first
check all known splices before further troubleshooting is
done.
A wire break can be located by gradually halving the
distance of the loop where the break may have occurred
until there is only a very short section of the wire left.
The following method does not work if
ECO mode is
activated. Make sure first that
ECO mode is turned off.
See
1. Check that the indicator lamp in the charging station
flashes blue, which indicates a break in the
boundary loop. See
Indicator lamp in the charging
2. Check that the boundary wire connections to the
charging station are properly connected and not
damaged. Check that the indicator lamp in the
charging station is still flashing blue.
R
GUIDE
L
POWER
3. Switch the connections between the guide wire and
the boundary wire in the charging station.
Start by switching connection L and GUIDE.
If the indicator lamp is lit with a solid green light,
then the break is somewhere on the boundary wire
between L and the point where the guide wire is
connected to the boundary wire (thick black line in
the illustration).
367 - 003 - 15.12.2017
Probleemoplossing - 49
