least 15 cm / 6 in. in height. This will prevent the
robotic lawnmower from ending up outside the
working area under any circumstance.
min. 15 cm / 6"
3.5.3 Boundaries within the working area
Use the boundary wire to isolate areas inside the
working area by creating islands around obstacles which
cannot withstand a collision, for example flowerbeds,
bushes and fountains. Lay the wire up to and around the
area to be isolated, and then return it back along the
same route. If pegs are used, the wire should be laid
under the same pegs on the return route. When the
boundary wires to and from the island are laid close
together, the robotic lawnmower can drive over the wire.
0 cm / 0"
OPGELET: The boundary wire may not be
crossed on its way to and from an island.
Obstacles that can withstand a collision, for example,
trees or bushes taller than 15 cm / 6 in., do not need to
be isolated with the boundary wire. The robotic
lawnmower will turn around when it collides with this
type of obstacle.
However, to achieve careful and silent operation, it is
recommended to isolate all fixed objects in and around
the working area.
Obstacles that slope slightly, for example stones or large
trees with raised roots, must be isolated or removed.
Otherwise the robotic lawnmower can slide up onto this
kind of obstacle causing the blades to be damaged.
3.5.3.1 Secondary areas
If the working area consists of two areas which the
robotic lawnmower has difficulty travelling between, it is
recommended to set up a secondary area. Instances of
this are slopes greater than 25% slopes or a passage
that is narrower than 60 cm / 24in. Lay the boundary
wire then around the secondary area so that it forms an
island outside of the main area. The robotic lawnmower
must be moved manually between the main and
secondary area when the lawn in the secondary area
has to be cut.
Secondary
area
Main area
The
Secondary area operating mode must be used as
the robotic lawnmower cannot travel on its own from the
secondary area to the charging station. See
Bedieningsmodus - 2e gebied op pagina 37. In this
mode, the robotic lawnmower will never look for the
charging station but will mow until the battery runs out.
When the battery is flat, the robotic lawnmower will stop
and the
Needs manual charging message will appear in
the display. Place the robotic lawnmower in the charging
station to charge the battery. If the main area should be
cut according to schedule after charging, operation
mode
Main area must be chosen and the Start button
must be pressed.
3.5.3.2 Passages when mowing
Long and narrow passages and areas narrower than 1.5
- 2 m / 3.2 - 6.5 ft. should be avoided. It is then a risk
that the robotic lawnmower travels around in the
passage or area for a period of time. The lawn will then
look flattened. The narrowest possible passage for the
robotic lawnmower is 60 cm / 24 in (between boundary
wires).
3.5.3.3 Hellingen
De robotmaaier kan op hellingen werken. De maximale
helling wordt gedefinieerd als een percentage (%) en
367 - 003 - 15.12.2017
Installatie - 17
