Message
Cause
Action
Stuck in charging sta-
tion
There is an object in the way of the robotic
lawnmower preventing it from leaving the
charging station.
Remove the object.
Upside down
The robotic lawnmower is leaning too much
or has turned over.
Turn the robotic lawnmower the right way up.
Needs manual char-
ging
The robotic lawnmower is set to the
Seconda-
ry area operating mode.
Place the robotic lawnmower in the charging
station. This behaviour is normal and no acti-
on is required.
Next start hh:mm
The schedule setting prevents the robotic
lawnmower from operating.
Change the schedule settings. See
breid op pagina 24.
The rest period is in progress. The robotic
lawnmower has an inbuilt standby period ac-
cording to the Standby time table.
This behaviour is normal and no action is re-
quired. See
38.
The clock on the robotic lawnmower is not
correct.
gina 38.
Today's mowing com-
pleted
The rest period is in progress. The robotic
lawnmower has an inbuilt standby period ac-
cording to the Standby time table.
This behaviour is normal and no action is re-
quired. See
38.
Lifted
The lift sensor has been activated as the mo-
wer has become trapped.
Free the mower
Collision sensor pro-
blem, front/rear
Mower body can not move freely around its
chassis.
Check that the mower body can move freely
around its chassis.
If the problem remains, the message requires
action by authorized service technician.
Wheel drive problem,
right/left
Grass or other object is wrapped around the
drive wheel.
Clean the wheels and around the wheels.
Safety function faulty Temporary electronic or software related is-
sue in the mower.
Restart the mower.
If the problem remains, the message requires
action by authorized service technician.
Electronic problem
Loop sensor problem,
front/rear
Charging system pro-
blem
Tilt sensor problem
Temporary problem
Temporary battery
problem
Temporary battery or software related issue
in the mower.
Restart the mower.
Disconnect and reconnect the battery.
If the problem remains, the message requires
action by authorized service technician.
Battery problem
Charging current too
high
Wrong or faulty power supply unit.
Restart the mower.
If the problem remains, the message requires
action by authorized service technician.
Connectivity problem Potential problem on the connectivity circuit
board in the mower.
Restart the mower.
If the problem remains, the message requires
action by authorized service technician.
Connectivity settings
restored
The connectivity settings was restored due to
a fault.
Please check and change the settings if nee-
ded.
Poor signal quality
The connectivity circuit board in the mower is
assembled upside down, or the mower itself
is tilted or upside down.
Verify the mower is not upside down or tilted.
If not, the message requires action by autho-
rized service technician.
367 - 003 - 15.12.2017
Probleemoplossing - 45
