Gardena PowerMax Li-40/32, Operating Instructions Manual

Page: 26 / 412

2. Dispose of lithium-ion cells properly.
Troubleshooting
Before you do troubleshooting
WARNING!
• Risk of physical injury!
• Cut injury when the blade turns or the
product starts accidentally.
• Wait for the blade to stop, remove the
safety key and use gloves before you do
troubleshooting.
To replace the blade
WARNING!
• Risk of physical injury!
• Cut injury when the blade turns and it is
damaged, bent, out of balance or has
chipped edges.
• Do not use the product when the blade is
damaged, bent, out of balance or has
chipped edges.
• Do not regrind the blade.
The GARDENA spare parts are availible from your
GARDENA dealer or from the GARDENA service.
Only use an original GARDENA blade:
•
GARDENA replacement blade Art. 4100
[5822490-01].
1. Let the blade replace by the GARDENA Service or a
specialist dealer authorised by GARDENA .
Troubleshooting table
Problem Possible Cause Remedy
Engine does not start.
Extension cable is disconnected or da-
maged. Connect the extension cable or if ne-
cessary replace it.
Blade is blocked. Remove the obstacle.
Engine is jammed and makes a
noise.
Blade is blocked. Remove the obstacle.
Cutting height is too low. Raise the cutting height.
Loud noises, the mower is rattling. Screws on engine, its fixing or on the
mower chasing are loose.
Have screws tightened by an authori-
sed specialist dealer or the GARDENA
Service.
Product runs unevenly or vibrates
strongly.
Blade is damaged or the blade moun-
ting is released. Have blade tightened or replaced by
an authorised specialist dealer or the
GARDENA Service.
Blade is very dirty. Clean the mower (see Maintenance). If
this does not rectify the problem, con-
tact the GARDENA Service.
Lawn is not cleanly cut.
Blade is blunt or damaged. Have blade replaced by the GARDENA
Service.
Cutting height is too low. Raise the cutting height.
26
22 - 001 - 05.10.2016