Gardena HE 32 4002, Operating Instructions Manual, Page: 5 / 14

17 16
G G
5.1 Connecting the unit
– cable lock / extension cable
Hattrick HE 32
(see ill. L / M)
Hattrick HE 36 / HE 40 (see ill. B)
First plug the extension cable (7)
from below into the base socket
of the combination switch / plug
(8). Loop the extension cable (7)
and insert it into the cable lock
(9) on the guide handle, allow the
lead to the socket to sag a little.
The cable lock prevents uninten-
tional disconnection of the elec-
tricity.
Lay out the surplus cable in loose
loops at the side of the cutting
lane and at the centre of the lane
length.
Note: Connect the extension
cable to the mains so that it
always feeds from the cut side.
5.2 Starting the Hattrick lawn
mower
Hattrick HE 32
(see ill. L)
Hattrick HE 36 / HE 40
(see ill. B / C)
Place your electric Hattrick lawn
mower on an even area of the
lawn.
To start the mower depress the
release button (10) on the combi-
nation switch / plug (8) and simul-
taneously pull the safety handle
(11) to the guide handle with the
other hand. As soon as the motor
starts you can release the release
button (10).
If you release the safety handle
(11) the motor switches off.
A built-in motor brake still the cut-
ting blades within three seconds.
Hattrick HE 32
If the aerator cylinder or the
cutting blades are blocked by
a foreign body or if the motor is
overloaded release the safety
handle (11) and
disconnect the
mains plug ! Remove the for-
eign body if necessary.
Hattrick HE 36 / HE 40
If the aerator cylinder or the cut-
ting blades are blocked by a for-
eign body or if the motor is over-
loaded the motor switches off
automatically within 20 to 35 sec-
onds due to the built-in overload
protection. In that case release
the safety handle (11).
Discon-
nect the mains plug ! Remove
the foreign body if necessary.
Note : In long, wet grass, to
start your electric Hattrick
easily, slightly raise one side
of the mower.
A
The switches installed
by the manufacturer must
not be removed or be bridged
eg : by taping down the safety
handle to the guide handle.
This will prevent the mower
switching off automatically,
and could cause fatal injury.
Attention! Cutting blades con-
tinue to run for three seconds
after the motor is switched off.
5. Using the product
using the screws (24) and
wing nuts (23) supplied.
Note: The cable should always
pass along the outside of the
frame (ill. I) and should never
be pinched or crimped.
4. To tighten the cable, put the
clamp (2) from outside onto
the lower part of the frame
(ill. I, detail).
4.2 Assembling the
Hattrick HE 36 / HE 40
Parts list check
The packaging of the HE 36 /
HE 40 should include the follow-
ing parts:
.
Electric Hattrick lawn mower
.
Grass catcher (disassembled)
.
Top of guide handle
.
Fastening elements
for guide handle
.
Operating instructions
with warranty card
.
TORX
®
-screwdriver for
changing blades
Mounting the guide handle
(ill. A)
1. Swivel the folded bottom part
of the guide handle (A 1) into
the working position and allow
it to engage. Tighten well with
the lower linkage locking
handles (2).
2. Put the top of the guide handle
(A 2) onto the bottom part of
the guide handle (A 1) and
secure using the fastening
bits (screw and plastic wing
nut).
3. Insert the connection cable
into the cable guide on the
wing screw (A 3).
Note: Only mount the screw
with the cable guide on the
cable guiding side of the
handle.
Mounting the grass catcher
(illustration sequences 1-5)
The grass catcher is supplied
loose (3 component parts).
The carrying handle (4) is below
the protective cover (15).
1. Unfold the grass catcher (3)
and insert the supporting frame
(5) through the opening of the
grass catcher (3) so that the
plastic base is on the bottom.
2. Then bend up the fastening
flaps (6) by hand according
to illustration 2 and use them
to fix the grass catcher (3)
to the supporting frame (5)
according to illustration 3.
3. Fasten the carrying handle (4)
by pressing the supporting
frame (5) according to illustra-
tion 4. The assembled grass
catcher is shown in illustration
5.
Note: The supporting frame (5)
is bent for fixing the carrying
handle (4).
HE 32 HE 36 / MulchCut HE 40 / MulchCut
Motor electric engine with brake
Power consumption 1300 W 1400 W 1600 W
Voltage 230 V 230 V 230 V
Frequency 50 Hz 50 Hz 50 Hz
Casing plastic plastic plastic
Cutting width 32 cm 36 cm 40 cm
Cutting height 25 - 55 mm 30 - 70 mm 30 - 80 mm
Weight 15.5 kg 20.6 kg 27.5 kg
Grassbox / grass catcher capacity 32 l 36 l 55 l
Wheels plain bearing plain bearing ball bearing
Working area related emission
characteristic value L
PA
1) 74 dB (A) 74 dB (A) 78 dB (A)
Noise level L
WA
2) 85 dB (A) 87 dB (A) / 89 dB (A) 88 dB (A) / 90 dB (A)
Vibrations a
vhw
1) < 2.5 ms
- 2
< 2.5 ms
- 2
< 2.5 ms
- 2
Measuring method 1) according to EN 836 2) according to 84 / 538 / EC
GARDENA Hattrick HE 32 / HE 36 / HE 40
1. Technical data
Please read and follow these
operating instructions carefully.
Familiarise yourself with the unit’s
features, its proper use and the
safety instructions included.
A
For safety reasons chil-
dren under the age of
16 or people not familiar with
these operating instructions
must not use this electric
Hattric lawn mower.
Please keep these instructions
in a safe place.
2. Operating instructions information
4.1 Assembling the
Hattrick HE 32
Parts list check
The packaging of the HE 32
should include the following
parts:
.
Electric Hattrick lawn mower
HE 32
.
Grassbox
.
1 handlebar frame upper
section (handle with switch)
.
2 lower handlebar frame
sections
.
Fasteners for handlebar frame
.
Operating instructions
.
TORX
®
-screwdriver for
changing blades
Mounting the guide handle
(ill. I)
1. Slide the lower sections of the
frame into the recesses so that
the flat sides point outwards.
2. Screw the frame in place using
the wing screws (25) supplied.
3. Place the guide handle (1) into
the hollow grooves and attach
it to the lower handlebar frame
4. Assembly
The GARDENA Hattrick HE 32 /
HE 36 / HE 40 lawn mowers are
designed for cutting and aerating
lawns in and around the garden.
They are not designed for use in
public facilities, parks, sporting
grounds, on roads, in agriculture
or forestry.
It is essential to observe the
manufacturer’s operating instruc-
tions to ensure the unit’s proper
functioning. The operating instruc-
tions also contain advice for
service, maintenance and repair.
A
Attention! To prevent in-
jury, the electric Hattrick
lawn mower must not be used
for trimming bushes, hedges,
shrubs, for cutting and pruning
of climbers or grass on roofs
or in balcony boxes. In addi-
tion, the electric Hattrick lawn
mower must not be used for
chopping up branches, twigs
or for levelling irregularities
in the soil.
3. Product use