Gardena 5031 D, Operating Instructions Manual

Page: 20 / 344

Safety Cut-Out to reset before you continue to use the
product.
Assembly
Before you do assembly
WARNING!
• Risk of physical injury!
• Cut injury when the blade turns or the
product starts accidentally.
• Wait for the blade to stop, disconnect the
product from the mains and use gloves
before you do assembly.
To connect the lower handle
2
2
1
1. Put both lower handles (1) in the product.
Make sure that the handles are fully in place and
the handle hole is inline with the threaded hole.
2. Put both screws (2) in the threaded holes in the
product.
3. Tighten the screws (2).
To connect the upper handle
1
5
5
6
4
3
1. Insert the cable lock (15) to the upper handle (4) with
the switch box (S).
2. Put the upper handle (4) on the lower handle (1).
Make sure that the handles are fully in place and
the handle holes are inline.
3. Push the screws (5) through the holes.
4. Put the washers (3) and the wing nuts (6) on the
screws (5).
5. Tighten the wing nuts (6).
20
32 - 001 -