Flower & Butterfly Wigwam Instructions
Contents:
6 x A (top pole with hole)
6 x B (bottom pole no hole)
6 x C Plastic Connectors
6 x Wooden Ball Spacers
2 x Strings
1 x Wigwam Canopy
Assembly instructions:
Step 1
Join one pole ‘A’ to one ‘C’ connector - slot the end of the pole with the groove cut into it inside
the connector - you will see that the connector has slots inside that will go into the groove in the
pole.
NB: If the pole is hard to get into the connector, a quick rub with sandpaper will help.
Step 2
Attach one pole ‘B’ into the other end of the connector (‘C’). This should give you a complete
pole.
Repeat Step 1 & 2 until you have 6 complete poles, each consisting of a top pole, connector and
bottom pole.
Step 4
Lay the canvas canopy on the ground and feed the poles through the elastic tabs on the inside of
the canopy (along the seam) this will hold them in place. Make sure that the top pole sections
(poles ‘A’, which contain holes) are at the top of the canopy (the narrow end). The bottom poles
(poles ‘B’) will sit in the canvas foot holders which sit on the bottom edge of the canvas canopy.
Step 5
Put the top end of the poles through the hole in the top of the canopy. Now take the string and
the wooden balls, thread the string through the first ball and then through the first hole in the
top pole (pole ‘A’).
Step 6
Next thread another ball onto the string then through the next pole. Once you have gone through all
of the top poles lightly tie the string together. Please note not to over tighten at this point or it will
prevent you from pulling the poles out to maximise the size of the wigwam.
