RTxxx LED controllers -User Manual
Copyright and disclaimer notice
Except as prohibited by law:
All hardware, software and documentation is provided on an ‘as is’ basis. This
information is for guidance only. Installers must perform their own risk assessment
specific to each installation.
It is essential that the user ensures that the operation of the product is suitable for
their application.
The user must ensure that incorrect functioning of this equipment cannot cause any
dangerous situation or significant financial loss to occur.
Deliberate acts of endangerment and vandalism are not covered by this document and
must be considered by the installer.
While care has been taken in the preparation of this document Gardasoft Vision Ltd will
not accept any liability for consequential loss of any kind except those required by law.
All trademarks acknowledged. This document is Copyright 2019 Gardasoft Vision Ltd.
EC conformity declaration
The EC Certificate of Conformity is available from Gardasoft Vision Ltd on request
Issue status of this document: Issue v013 - July 2019
RTxxx LED controllers -User Manual
Contents
1
Getting started
5
1.1
Summary of features
5
2
Safety
7
2.1
Heat
7
2.2
Electrical
7
2.3
General
8
2.4
Installation guidance (disclaimer)
9
3
Sicherheit
10
3.1
Wärme
10
3.2
Elektrik
10
3.3
Allgemein
12
3.4
Installationsanleitung (Haftungsausschluss)
12
4
Sécurité
13
4.1
Chaleur
13
4.2
Électricité
13
4.3
Généralités
15
4.4
Guide d'installation (clause de non-responsabilité)
15
5
Mounting the RTxxx
16
5.1
Environmental considerations
16
5.2
Electrostatic discharge
18
6
Connections
19
6.1
Power supply
19
6.2
Lighting output
19
6.3
Trigger inputs
22
6.4
12V Power output
23
6.5
Ethernet connection
23
6.6
Serial connection
23
6.7
Connectors
23
7
General description
25
7.1
Output modes
25
7.1.1
Continuous output, switched output, selected output
26
7.2
Pulsed output
26
7.3
Fault detection
27
7.4
Light auto-sensing
27
7.5
Cold start
28
8
Lighting setup
29
9
Front panel configuration (RT200)
30
9.1
Startup
30
9.2
Setting the light rating
31
9.3
Setting up continuous output
32
9.4
Setting up switched output
34
9.5
Setting up selected output
36
9.6
Setting up pulsed operation
38
9.7
Setting time periods
41
9.8
Setting the internal trigger timer
43
9.9
Using the key lock
44
WWW.STEMMER-IMAGING.COM