RC1xx LED Lighting Controllers - User Manual
—
32
—
Where
m
= flags as follows:
bit 1 = 0
1
E flag set (error detection enabled)
E flag cleared (error detection disabled)
bit 2 = 0
1
P flag set (positive triggers)
P flag cleared (negative triggers)
bit 3 = 0
1
Autosense set (controller waits for light to be
connected
No Autosense (controller assumes light is
connected)
bit 6 = 1
Enable current adjust
Disable current adjust
Note:
Bit 0 is the least significant bit.
Set the internal trigger
These commands control the internal trigger. When set, the output is
triggered using an internal trigger signal. Type in:
TT0
to disable the internal trigger
TT1
to enable the internal trigger using the period last set
TT1,p
to enable the internal trigger and set the period.
Where:
p
= trigger period in milliseconds (10ms to 5s).
Note 1:
The TT1 command does not disable external triggers.
Note 2:
This setting can be saved to non-volatile memory using the
AW
command.
To view the status of the internal trigger, type in:
ST0
A typical reply to this command might be:
TM1,TP20.00ms
Where:
TM
= Trigger status. 1 is
on
, 0 is
off
TP
= Trigger period
Show configuration
This command shows the configuration of the RC120. Type in:
ST
