96
97
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
Guided Calibration (recommended)
This calibrating method will allow calibration of each individual height sensors to the original standard
height using a simpler approach. No calculations are required
and only one iteration is necessary
.
Upon entering, instructions will be displayed.
Notes:
• Measurements of each corner are made from the bottom of the wheel arch to the center of
the wheel. They can be made in metric or imperial
.
Figure 51.
Wheel measuring
•
The current (top) and new calibrations (bottom) of each sensor is shown here. It is an arbitrary
constant and does not refer to the height measurement. This new calibration value will only
change when the send button is pressed. The current height value is shown in the middle.
Figure 52.
Calibrations values
