Gap Diagnostic IIDTool Pro G3, User Manual

Page: 51 / 188

50 51
IIDT
ool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
2.8.2 Connecting the IIDTool
Once the OBDII connector is located, the unit can now be connected.
Connection steps
1- Ensure compliance with safety instructions and tips to avoid battery drainage (
section 2.7
)
2- Switch on the ignition or start the engine* if outside. Respect the safety instructions (
section
2.7.1
)
3- Locate the OBDII connector (previous section)
4- Insert the IIDTool into the OBDII connector
5- Wait for about 30 seconds while the tool is scanning electronic communication buses.**
6- Launch the IIDTool Interface of choice and navigate as described in the next segment.
-If it turns out that communication with one of the buses is not possible, an error message will
appear. See the Frequently Asked Questions (FAQ) section on the manufacturer’s website for
a solution to this problem:
https://www.gap-diagnostic.com/
.
*Connecting the tool without having the engine running or ignition ON will prevent proper scanning
of ECUs. Always connect the tool after turning ignition ON or starting the engine. See the Frequently
Asked Questions (FAQ) section on the manufacturer’s website for a solution to this problem:
https://
www.gap-diagnostic.com/
.
** Pro This waiting time is only present upon first connection of the tool on a new vehicle and following
an update of the firmware of IIDTool. BT This waiting time is present when connecting to a vehicle on
which the tool is unlocked or following an update.
2.8.3 Mobile Application, Navigation and Controls
Definition
The App was developed by the manufacturer with user friendliness in mind. Details on installations and
compatibility for each interface are available at the section 1.7 and section 2.4.3 of this manual.
Prerequisites
• Own an IIDTool
BT
or IIDTool
Pro
• Have access to the vehicle on which the IIDTool will be used
• Ensuring that the vehicle is in a safe environment ( section 2.7.1 )
• Having taken precautions to avoid battery drainage ( section 2.7.2 )
• Own a compatible mobile device ( section 1.7.3 ) on which the Bluetooth module is “ activated ”
or “ ON ” ?
• IIDControl App installed in the mobile device ( section 2.4.3 ) and having synchronized it with the
tool ( section 2.6 )