144
145
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
Trigger feature
This feature allows automatic controlling of live data recording, start and stop, by comparing live values
relative to defined target values. The mobile device buzzer (sounder) and/or vibration can also be acti
-
vated when a target is reached.
The trigger button will become visible once a live value is selected. Only one trigger type (start/stop or
event) can be selected per live value.
Figure 75.
LV : Trigger, start stop
Figure 76.
LV : Trigger, event
Start and stop controlled
This mode allows setting both start and stop tar
-
get conditions independently. The start and stop
events are independent meaning that live value A
can be used to start the log while value B is used
to stop the recording.
Event
This mode is used to pinpoint a specific event.
Both the start and stop conditions are equal thus
occurring at the same time.
Figure 77.
LV : Erasing trigger settings
Use the clear all button to erase all triggers. The clear button will erase only the one currently viewed.
The icons significations can be viewed by clicking on the i button (bottom right).
