104
105
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
4.6.11 Active Damping (L320)
Calibration
Required to when replacing the Active Damping ECU.
4.6.12 HCMB Rear View Mirror (L405 and L494 2014-2015)
Calibration
This routine is used when this ECU is replaced with a brand new one. This is not required with installing
or retrofitting a used unit.
4.6.13 IPMA Rear View Mirror (L405 and L494 2016 to 2019, L462 up to 2019)
Calibration (2016)
This routine is used when this ECU is replaced with a brand new one. This is not required with installing
or retrofitting a used unit.
4.6.14 Camera Calibration Instructions to be performed after 4.6.13 or 4.6.14
Please note : During the following application, a 3 - 5 minute drive cycle will be required in order to
successfully calibrate the forward-looking camera
The following screen will present you with a list of instructions crucial to the running of the calibration
routine during the drive cycle, therefore it is very important that you have read and understood them
before continuing with the application.
The following routine will calibrate the forward-looking camera during a drive cycle of 3 - 5 minutes.
This time may increase if the instructions cannot be followed correctly.
Allow Central Configuratin Data Learning (2017-2019)
This routine is used when a CCF change taken into account by this ECU is made. Auto High Beam
Assist and Lane Keep Assist to name a few.
4.6.15 BCM Body Control (L319, L320)
Steering column calibration
This routine is required when the steering column is replaced. Upon request only as a special firmware
is required.
