GT7 Terminal
Configuration
www.gantner.com
HB_GT7-2x00-3x00--EN_12
29
5
CONFIGURATION
RF exposure statement
The users must keep at least 20 cm separation distance from the device, except during the identification and operation
process at the device (e.g., touch screen input), which must be performed as described in this manual.
5.1
Target Group
This chapter provides information for technicians responsible for commissioning and configuring the GT7 terminal.
Basic knowledge of electronics and web applications is required. GANTNER recommends that the configuration of
the system be completed by trained personnel only. GANTNER regularly offers training for its partners.
This chapter contains information on all configuration settings of the GT7 terminal that are independent of the apps.
In addition to the direct web interface, configuration can also be performed via the G7 Connect web platform. The
web browser software G7 Connect can also be used to configure the GT7 terminal. A G7 Connect manual is
available that describes the operation of this software in detail.
5.2
Requirements for Use
- Min. firmware version 2.1 must be installed in the GT7 terminal.
NOTE!
The firmware can be installed via the web interface or via the GANTNER Cloud (see “5.6.21 Update Firmware “).
- The configuration is valid for the GT7.2x00, GT7.3x00, and GT7.3x01.
5.3
Configuration Options of the GT7 Terminal
The configuration and functionality of the GT7 terminal can be defined in different ways:
Via the configuration menu: “5.4 Configuration via the GT7 Terminal“
Basic information and settings are accessible and configurable via the configuration menu of the GT7 terminal.
Via G7 Connect: “5.5 Configuration via G7 Connect (GANTER Cloud)”
The GT7 terminals in a system integrate conveniently into the GANTNER Cloud. There, all terminals are listed in an overview
for the user and if the devices are online, they can be configured directly via this platform.
Via the
web interface: “5.6 Configuration via Web Interface“
In a web browser, an HTTP or HTTPS connection to the GT7 terminal is established and the GT7
terminal’s integrated web
server with all the configuration settings is displayed after login.