GAT Access 6100 Terminal Series
Operation
www.gantner.com
HB_GAT-ACCESS6100--EN_14
67
6.4.2
Additional Acknowledgment or Selection by the User
Depending on the configuration settings of a GAT Access 6100, the user may be requested to additionally press the
acknowledge key after the data carrier is read. In this case the terminal displays the text as shown in Figure 6.6, the
4-segment LED display flashes green and two acoustic signals are emitted.
Figure 6.6 - Information display if the user must press a key
The user must press one of the four keys below the display to gain access, otherwise access is denied.
6.4.3
Problem when Writing to the Data Carrier
If there was a problem when writing to the data carrier (e.g., with the Locker Check-In function), a GAT Access 6100
will show the following message (Figure 6.7). Reasons for this error may be that the data carrier was held not long
enough in front of the scan field or the data carrier is damaged.
Figure 6.7 - Problems when reading the data carrier
Summary of Contents for GAT ACCESS 6100
Page 10: ...GAT Access 6100 Terminal Series Table of Contents 10 HB_GAT ACCESS6100 EN_14 www gantner com ...
Page 34: ...GAT Access 6100 Terminal Series Installation 34 HB_GAT ACCESS6100 EN_14 www gantner com ...
Page 80: ...GAT Access 6100 Terminal Series Operation 80 HB_GAT ACCESS6100 EN_14 www gantner com ...
