G&D VisionXS-IP-F-DP-UHR, Installation And Operation Manual

Page: 217 / 232

Further information
G&D VisionXS-IP-F-DP-UHR · 96
English
Determining network settings via service port
If you do not know the IP address of an already configured user or computer mod-
ule, you can use the service port of the module to find out the address.
Use any terminal emulator (e.g.
Tera Term
or
PuTTY
) to show the log messages of
the modules.
Installing the device driver
Before establishing a connection using the terminal emulator, install the device
driver CP210x USB to UART Bridge VCP .
How to install the device driver to address the service port:
1. Use any web browser to open the website www.gdsys.com/en/start .
2. Go to More from G&D > Tools & Driver .
3. Download the device driver for the operating system installed on the computetr.
4. Execute the file and follow the instructions of the installation wizard.
Establishing a connection by using a terminal emulator
How to establish a connection using a terminal emulator:
1. Start any terminal emulator (e.g. Tera Term oder PuTTY ).
2. Establish a new connection via terminal emulator and enter the follwoing set-
tings:
 Bits per second: 115.200
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow control: None
3. Use the supplied USB service cable to connect the computer to the Service port on
the front panel of the user or computer module.
NOTE: When connected to a service cable, the driver provides the
Service
port of a
user or a computer module as a virtual serial interface (COM port). The virtual
interface can then be selected to establish a connection using the terminal emula-
tor.