G&D VisionXS-IP-F-DP-UHR, Installation And Operation Manual

Page: 206 / 232

Configuration
85 · G&D VisionXS-IP-F-DP-UHR
Changing the scancode set of PS/2 keyboards
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the PS/2
keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe “|” or the arrow keys do not
work as expected.
How to change the setting of the scancode set:
OSD
1. Press Ctrl+Num ( default ) to open the OSD.
Select the row Console setup and press Enter .
2. Under Scancode set press F8 to select one of the following options:
2  activates scancode set 2 for PS/2 keyboard inputs
3  activates scancode set 3 for PS/2 keyboard inputs
3. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.