G&D VisionXS-IP-C-DP-UHR, Assembly, Installation And Operation

Page: 88 / 144

Start-up
13 · G&D VisionXS-IP-C-DP-UHR
Start-up
After the proper installation of the KVM extenders they can be immediately put into
operation.
Mind the following activation sequence when starting the modules:
1. Switch on the external power supply of the user module
or switch on the internal power supply (desktop variant only).
2. Switch on the external power supply of the computer module
or switch on the internal power supply (desktop variant only).
3. Turn on the computer that is connected to the computer module.
Starting process
After the computer module and the user module are turned on, the LEDs on the
back panel show the module’s operating status.
For further information about this topic, also see the chapter
Status LEDs
on
page 58 ff.
On-screen display of the user module
When starting the user module, information about the starting process as well as the
firmware versions and IDs of the connected modules are displayed in the monitor of
the user module.
Additionally, the
local hotkey
(default:
Alt
+
Num
) to open the local OSD of the user
module and the remote OSD
remote hotkey
(default:
Ctrl
+
Num
) to open the remote
OSD of the computer module are shown.
NOTE: The recommended activation sequence ensures that the KVM extenders
are able to read out the features of the connected monitor and to transmit them to
the computer (see
DDC transmission with cache function
on page 55).
ADVICE: Press Pause to stop the process. Pressing Space continues the process.