G&D VisionXS-F-DP-UHR, Installation And Operation Manual

Page: 148 / 216

Web application Config Panel
36 · G&D VisionXS-F-DP-UHR
Web application Config Panel
The Config Panel web application provides a graphical user interface to configure and
monitor the KVM extender.
Basic operation of the web application
The web application can be used in the entire network independently from the loca-
tions of the devices and consoles connected to the KVM system.
Starting the web application
How to start the
Config Panel
web application:
1. Enter the following URL in the address bar:
https://[IP address of the user or computer module]
2. Enter the following data in the login mask:
3. Click on Login .
Selecting the language of the web application
How to change the language of the web application:
1. Click the language identifier of the current language in the upper right
corner.
2. Switch the language to be used by clicking on the desired language.
NOTE: The separate manual provides information about system requirements, the
required configuration of the network interfaces at the VisionXS-F-DP-UHR devices
and the operation of the web application.
Username:
Enter a username.
Password: Enter a password for your user account.
IMPORTANT:
Change the administrator account's default password.
The default access data is:

Username: Admin

Password: see login information on the label on the bottom of the device
NOTE: The selected language is saved in the user settings of the active user. The
next time this user logs on, the previously selected language setting is applied.