Configuration
G&D VisionXS-F-DP-UHR ·
48
English
Changing the scancode set of PS/2 keyboards
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
How to change the setting of the scancode set:
ADVICE:
Use the scancode set 3 if you cannot enter the pipe “|” or the arrow keys
do not work as expected.
OSD
1. Press
Ctrl+Num
(
default
) to open the on-screen display.
2. Select the row
Console setup
and press
Enter
.
3. Under
Scancode set
press
F8
to select one of the following options:
2
activates scancode set 2 for PS/2 keyboard inputs
3
activates scancode set 3 for PS/2 keyboard inputs
4. Press
F2
to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
Config
Pan
el
1. In the menu, click on
KVM extender
.
2. Click twice on the user module (
CON-Trans 1
or
CON-Trans 2
) you want to con-
figure.
3. In the
Scancode set
field of the
Configuration
section, select one of the follow-
ing options:
Set 2
activates scancode set 2 for PS/2 keyboard inputs
Set 3
activates scancode set 3 for PS/2 keyboard inputs
4. Click on
Save
.
5. Turn the KVM extender off and back on again.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
Summary of Contents for VISIONXS-F-DP-UHR Series
