Configuration
G&D VisionXS-F-DP-HR ·
77
English
Changing the scancode set of PS/2 keyboards
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
How to change the setting of the scancode set:
ADVICE:
Use the scancode set 3 if you cannot enter the pipe “|” or the arrow keys
do not work as expected.
OSD
1. Press
Ctrl+Num
(
default
) to open the OSD.
2. Select the row
Console setup
and press
Enter
.
3. Under
Scancode set
press
F8
to select one of the following options:
2
activates scancode set 2 for PS/2 keyboard inputs
3
activates scancode set 3 for PS/2 keyboard inputs
4. Press
F2
to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
Summary of Contents for VisionXS-F-DP-HR
