Initial configuration of the network settings
G&D VisionXS-C-DP-UHR ·
21
English
Configuring the network interface
How to configure the network interface:
1. Use the
local hotkey
(default:
Alt
+
Num
) to open the local OSD to configure the net-
work interface of the
console module
or use the
remote hotkey
(
default
:
Ctrl
+
Num
) to
open the remote OSD to configure the network interface of the
computer module
.
2. Select the entry
Network
(local OSD) or
Network setup
(remote OSD) and press
Enter
.
3. Select the entry
Interfaces
and press
Enter
.
4. Enter the following data under
Interface A
:
5. Press
F2
to save your settings.
Operational
mode:
Press
F8
to select the operational mode of the interface:
Off:
switch network interface off.
Static:
A static IP address is assigned.
DHCP:
IP address is obtained from a DHCP server.
IP address:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Netmask:
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
Summary of Contents for VisionXS-C-DP-UHR
