G&D USB-Splitter-2, Installation Manual, Page: 32 / 40

Installation
10 · G&D USB-Splitter-2
Connecting the power supply
Power In: Connect the table power pack to this interface.
Power Loop: Optionally plug a power loop cable (order no. A6400042) into this inter-
face. Plug the other end of the cable into the Power In interface of the next device
ADVICE: If the power supply of the device with the table power pack is carried out
via the Power In interface, up to two further devices can be supplied with power by
using power loop cables.
IMPORTANT: A maximum of three identical USB-Splitter-2 may be connected to
the supplied table power pack.
Power In
+ Loop
Keyboard
Generic
Status
Fail
0
1
3
7
2
4
6
8
5
9
Mode Service Keyboard Generic
Power Loop
Port A
Port B
Status
Fail
Port A Port B