Installation
4
· G&D DVIVision
Installation
The computer module is placed close to the computer to be operated through the
DVIVision system. If desired, a separate user console can be optionally connected to
the computer module. The desktop environment of the user includes a monitor, a
keyboard and a mouse.
The user module is connected to the computer module using a category 5e (or bet-
ter) twisted pair cable. The remote console is connected to this module.
Preparation
1. Ensure that the computer to be connected to the DVIVision system is turned off.
If the computer is provided with keyboard and mouse, unplug the cables of the
input devices from the interfaces.
2. Place the computer module (DVIVision-CPU) close to the computer. Please
mind the maximum cable length of
five
metres between the computer module and
the computer to be connected.
3. Place the user module (DVIVision-CON) close to the remote console. Please also
mind the maximum cable length of
five
metres between the user module and the
devices of the user console.
4. Take the supplied cables of the DVIVision system, and place them ready for
installing the devices. The scope of delivery of both the computer module and the
user module provides an IEC cable and a set of signal cables, which are listed on
the following page.
When choosing a place for the device, please ensure to comply with the ambient
temperature limit (see
on page 45 ff.) close to the device. The ambi-
ent temperature limit must not be influenced by other devices.
When installing the devices, make sure to only place a maximum of three devices
directly on top of each other. Therefore, a good circulation of air is enabled and a
mutual thermal interference can be avoided. After having installed three devices,
provide for a distance (at least 2 cm).
Avoid to cover the ventilation openings of the variants which include ventilation open-
ings. For reasons of electric safety, the device only has to be installed horizontally.
