G&D DP1.2-VisionXG-Fiber Series, Installation And Operation Manual

Page: 140 / 156

Background information
59 · G&D DP1.2-VisionXG-Fiber
The monitor’s E-EDID information is usually transmitted one-to-one to the com-
puter. In case, the KVM extender determines that the display cannot be read with-
out errors or that the entries are invalid, the information is completed or corrected (if
possible).
Reading out the adjusted IP address
If the IP address of a copmuter module or a user module is unknown, a terminal
emulator (for example
HyperTerminal
oder
PuTTY
) can be used to read it out.
Use the supplied service cable tp connect the computer on which the terminal emu-
lator is installed to the
Service
socket of the computer module and the user module.
How to read out the preset IP address of the device:
1. Turn the device off.
2. Start the terminal emulator.
3. Enter the following conection settings:

Bits per second: 115.200

Data bits: 8

Parity: None

Stop bits: 1
4. Turn the device on and read the IP address in the terminal emulator.
NOTE: Before establishing a conenction to the terminal emulator, install the
CP210x USB to UART Bridge VCP
device driver.
This driver provides the Service socket of the
DP1.2-VisionXG-Fiber
system as virtual
serial interface (COM port). The virtual interface can now be selected to establish
a connection to the terminal emulator.
The driver can be downloaded at
www.gdsys.de
under
Downloads > Driver
.