Configuration
32
· G&D DL-Vision(M/S)
Freeze mode
If the cable connection between computer and user module fails during operation, the
KVM extender no longer displays an image at the console monitor.
Enable the
Freeze
mode if you want the last available image at the user module to be
displayed after the connection was interrupted. The image will be displayed until the
connection is re-established.
How to configure the freeze mode:
TIPP:
To highlight a failure in the connection, the last available image can be dis-
played either with a coloured frame and/or the popup stating
Frozen
.
Conf
ig
Pan
el
1. Click on
KVM Extenders > [All Extenders]
in the tree view.
2. Double-click the computer module of the KVM extender to be configured.
3. Click the
Console
tab.
The Freeze mode can be disabled/enabled for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
4. Use the
Freeze mode
box to choose between the following options:
Disabled
show no image when disconnected (default).
Enabled
show last available image when disconnected.
5. If the
Freeze
mode is disabled, you can use the
Freeze visualization
box to
disable the following options.
Frame
shows a coloured frame when disconnected.
OSD
shows
Frozen
when disconnected.
6. Click
OK
to save your settings.