User Manual
39
Interference
Attention!
Always remove the plug from the socket when carrying out
repairs!
The cabinet does not start.
• Check the plug.
• R
estore the power supply by replacing a fault fuse or by using the
on/off switch.
• Contact your local service
organization.
Temperature is too high, in spite of recent adjustment of
thermostat.
• Check/restore
power supply.
• Remove contents
which may obstruct ventilation.
• Clean magnetic seal, replace if necessary.
Remove contents which
may obstruct ventilation
• Defrost evaporator.
• The condenser is dirty, must be cleaned (applies only for GM
2/212)
•
Thermostat or compressor is defect.
•
Fan (evaporator or condenser) is defect.
• Contact your local service organization.
Temperature is too low, in spite of recent adjustment of
thermostat.
•
Thermostat is defect.
• Contact your local service organization.
Water leak
•
Defrost regularly
–
if necessary extra manual defrost cycle.
•
Check if the product is leveled. If necessary level the product.
•
Contact your local service organization.
Plug lead
•
To prevent accidents the plug lead, if damaged, may only be replaced
by the service/maintenance organization or qualified installer.