background image

Page 1 of 6

Four channel setting switches are on the control box. The MODE switch is the left one and nearest the red LED power 

indicator. The right hand switch is the X1 DMX.  

Address then X10 and X100

It is powered by 24 volt DC and controlled by DMX512, either from most color scroller power supplies or a standalone power 

supply. Once powered, the unit will show a red power LED to indicate the power is on. The unit is also fitted with a green 

LED which indicates the status of operation. After it is powered, the unit needs to initialize to find the home position of the 

gobos. This takes about 2 seconds during which time the green LED will flash. Once the home sensing is complete the 

flashing will stop. If the LED is not lit then DMX is not present. If the LED continues flashing, it means there has been a fault 

detecting the sensor and the unit operates but without correct index positioning.      

SX4

® 

FOUR & SIX GOBO CHANGER OPERATING INSTRUCTIONS

X1

MODE

X10

X100

Red Green

  MODE 

DMX CHANNELS 

 

FUNCTION

 

Standlone: slect one gobo for focus

 

DMX gobo select by fader

 

DMX Vgobo select - speed & position

 

Standalone: speed, direction, timed

 

Standalone: 2 to 6 gobos, timed

 

Standalone: continuous rotate, set speed

 

DMX controlled rotation only

 

DMX control index / rotate one fader

 

DMX index/rotate on two faders

 

16 bit indexing / 10,000 positions

--------------- CAUTION ----------------

When using a DMX device with a discharge lamp such as CDM or an HMI, it's suggested that you separate the power circuit for the discharge

lamp from the DMX control device. When using DMX controlled units such as an Indexing TwinSpin™ or SX4® Gobo Changer or DMX Loop Tray,

the "noise" from the discharge lamp ballast may cause some interference and or damage the electronics. For best results we recommend 

providing separate line voltage to the DMX devices and the discharge light fixture.  

  

Reviews: