Revision 3, 6 February 2017, Page
1
of
3
Product Installation Guideline
SMVA21 (42030)
SPECIFICATIONS
This product has a unique design concept that eliminates the institutional look and provides anti-
ligature features and vandal resistant compliance.
Easy operation allows the shower to be activated with your palm or fingers.
170mm round face plate with polished stainless steel finish for a homely look, but is able to
withstand heavy knocks.
Easy Temperature blending and operation to ensure comfort and safety for the user.
Bevelled edges for maximum tight fixing.
This item is designed for easy panel installation (Maximum thickness 18mm).
Access to the rear of the unit is required to fit this product.
Water supplies shall be at reasonably balanced pressures from a common source (e.g. hot and cold
supplies both from the same storage or both from a supply pipe). Where the fitting is supplied from
unbalanced supplies (e.g. hot and cold supplies from
separate sources) an ‘Approved’ single check valve
or some other no less effective backflow prevention device shall be fitted immediately upstream of both hot
and cold water inlets.
TECHNICAL DATA
Inlet connections (BSP Female)
1
/2”
Working Pressure Range (kPa)
Min
150
Max 500
Maximum Working Temperature (°C)
41
NOTE:
As the Galvin Specialised Design and Development team continually strive to improve our products, specifications may change without
notice.
PRE-INSTALLATION
MOUNTING DETAILS
– HOLE CENTRES
Cut
70mm-
72mm hole in mounting panel then drill 3
holes
8mm as shown in the rough in details
Maximum panel thickness to be 18mm
Tools required: Power drill, spanner or adjustable cresent
