2
Version 1, 21 August 2019, 2 of 21
2.0
SAFETY
The CliniMix
®
Thermostatic Progressive Mixing Valve is a high-performance valve designed to give stable
and dependable operation, provided it is installed, commissioned, operated and maintained as per the
recommendations outlined in this manual. It should be noted however that this valve should not be
considered as an alternative to adequate supervision and duty of care during its use and operation.
Note: The mixing valve, inlet controls, pipe work and the surrounding area may become hot when
installed which may cause burn injuries. Precautions should be taken to ensure that these surfaces
cannot cause such injuries
.
3.0
DESCRIPTION
This manual covers the CliniMix
®
Wall Mounted Thermostatic Progressive mixers with proximity sensor.
These are designed to provide water in stable temperature for hand washing. This mixing valve is supplied
with integral isolating valves, strainers, check valves and flow regulators and is provided with a facility for
thermal disinfecting of the cold inlet side and mixed water outlet for the wall mounted version only.
The hot side of the body and the inlet is insulated to ensure the body surface is maintained at a safe
temperature when the fitting is in operation.
Avoid using heat for soldering near the mixer inlets to prevent damage to internal components.
4.0
DIMENSIONS
−
The rough in details have been provided to show
correct fitment of the Progressive Mixer (see below
image).
−
A cavity must be supplied to fit sensor on the back
of faceplate as shown, minimum 20mm deep.
−
Drill 2 x mounting
6.0x30 deep holes, location as
shown.
Note: Maximum spud length to be 15mm. See
below image position of sensor from basin.
TYPICAL INSTALLATION VIEW
