ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 62 of 132
the ViscoSite Software via the Alarms Display section of the
Display Setup screen. See Section 5.6.3 for information on
how to configure the Alarm DISPLAY limits.
Alarm parameter selection and alarm limits for analog
outputs and relays
cannot
be set from within this sub menu.
Output
alarm parameter selection and alarm limits for
Analog Outputs and Relays are configured through the
Output Configuration Menu for Analog Outputs and Relays.
See Section 4.5 below
.
Display Units Submenu
4.4.4.1 Accessing the Display Units Submenu
With the cursor on Display Units, Press
ENTER
.
The submenu screen in Figure 4.6 is displayed.
Figure 4.6: Display Units Submenu
This submenu allows selection of measurement units for
each parameter displayed on the LCD. The unit choices for
each parameter are shown in Table 4.5.
Measurement
Parameter
Selectable Units
Viscosity
cP x g/cm
3
(Centipoise Density product)
mPa x sec (millipascal Seconds product)
cP (Centipoise)
cSt (Centistoke)
Density
g/cm
3
Temperature
°C
°F
Distance
Metres
Feet
Table 4.5: Selectable Display Units for each Measurement
Parameter
