ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 26 of 132
3 Receipt, Unpacking, Proper Handling, and Installation
3.1 Receiving the System
When the system arrives, inspect the packaging for external signs of damage. If
there is any obvious physical damage, DO NOT OPEN. Contact the shipping
carrier’s
agent and Galvanic Applied Sciences immediately to report the damage.
Please request that the carrier's agent be present when the packaging is opened
and the system is unpacked. Document all observed damage or suspected
damage in writing
3.2 Unpacking the System
Assuming no obvious physical damage:
•
Open the shipping container and remove all packing material and boxes.
•
Visually inspect the system and accessory packages to ensure that no major
damage has occurred.
•
If damage has occurred,
stop
and contact the shipping carrier and Galvanic
Applied Sciences.
•
Do not proceed
with system installation.
Do not attempt to facilitate repairs yourself as this will likely negate / invalidate
any possible shipping insurance claim and WILL void your warranty.
Place the small packages aside in a safe, secure storage area until installation.
IMPORTANT!
PLEASE KEEP THE SHIPPING CONTAINER (CRATE/BOX) AND ALL PACKING
MATERIALS FOR THE TRANSDUCER FOR RETURNING THE TRANSDUCER TO
THE FACTORY FOR SERVICE.
Failure to do so may lead to transducer damage should shipping to the factory
become necessary and may void any remaining warranty on the system.
Please contact Galvanic Applied Sciences if you require factory approved
shipping materials.
Transducers are shipped in cardboard containers or wooden crates as dictated
by the dimensions of the transducer. The two types of packaging are shown in
Figure 3.1.
