ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 119 of 132
The filtering dialog box shown in Figure 11.2 is for the
data
type
column.
The upper portion of the dialog lists all of the values in the column.
•
Place a checkmark in the box to the left of the item by which to filter.
•
Enter specific values or value ranges expressed in Boolean logic in
the bottom half of the screen if so desired. The Boolean approach
works best with numeric values.
•
Click “Filter.”
•
The filtered results are displayed based on the selections.
•
For example, in Figure 11.2, placing a checkmark in the ‘Date’ box
and clicking “Filter” will filter and display ONLY registers that have
the ‘Date’ data type. Multiple filtering criteria may be selected for
advanced filtering.
Clearing All Currently Applied Filters
•
Click the “Clear Filter” button
.
11.3 Modbus Data Types
The Modbus list contains a number of different data types. The data types are
summarized in Table 11.1 below.
Data Type
Explanation
Allowed Values
Analog
Measurement
Stores selected
measurement parameters
associated with relay
alarms
0
No Output
1
Density
2
Viscosity Parameter
3
Probe Temperature
4
Dome Temperature
5
Electronics
Temperature
6
Oscillation Frequency
7
Temperature
Compensated
Viscosity
Boolean
Stores status of Manual
Density enabled
(default=1) and
TimeAverageViscosity
enabled (default = 0)
0
Off / False
1
On / True
(cP x g/cm
3
) x
1000
Stores Calibration
Viscosities / Temperatures
and Low/High
Temperature Calibration
Limits (note units)
Any integer value
Date
Date associated with
calibration
Date in the format
mmddyytttt
