Galvanic Applied Sciences 943-TGS-CE, Operation Manual

Page: 148 / 158

Revision 5 148 August 2021
Table 37: IO Board Web GUI Pages
Page Title Manual Section Purpose
Status 12.2
Presents the current status of all inputs and outputs
(analog and digital) on the IO board; all data is read
only.
Manual
Override
12.3
Used for testing of digital outputs (solenoids and
relays) as well as for calibration of the four analog
outputs
Analog Inputs N/A
Used for calibration of the analog inputs used for
pressure, temperature, and other analog signal
measurement inputs to the IO board.
NOTE: This section is for factory engineers only.
Firmware N/A
Used for upgrading the IO board firmware.
NOTE: This section is for factory engineers only.
12.2 Status Page
The Status page shown in Figure 93 shows the current status of the inputs and outputs that are
under the supervision and control of the IO board. The information on this page is read-only and
cannot be edited by the user.
Figure 93: Status Page
At the top of the page is an Online indicator which indicates whether the board is under the
control of the analyzer’s control computer. In normal operation, this will always be green. The
indicator will be red ( Direct Board Control ) only when the IO board has been switched to Direct
Peripheral Board Control
for calibration and/or testing of the board’s inputs and outputs. Refer
to Section 12.3 for more information. The Firmware Revision field shows the current firmware
version installed on the IO board, which may be useful for troubleshooting purposes. The On
Board Temperature field shows the current temperature measured by the IO board’s on board
temperature sensor.
The remaining five boxes on this page are explained in Table 38.