Back Sheet 3 of 7
Operating The Lift To Remove Components
1. Always follow the vehicle manufacturer’s recommended service procedure for removal of the component.
2. Position the lift under the vehicle. Connect the air hose to the air pump.
3. Press the end of air pump foot pedal marked
to raise the lift to the load.
4. Remove any remaining bolts from the vehicle component.
5. Press the end of the air pump foot pedal marked and lower the lift completely.
6. Move the lift and load out from under the vehicle.
Operating The Lift To Install Components
1. Position the lift under the vehicle chassis.
2. Align the component in the correct position and press the end of the air pump foot pedal marked
to
raise the lift.
3. Always follow the vehicle manufacturer’s recommended service procedure for installing the component.
Inspection and Maintenance
CAUTION: To prevent personal injury,
•
Only qualified personnel shall perform inspections and repairs to this lift.
•
Before each use, inspect the lift for bends, cracks, dents, elongated holes, or missing hardware. If
damage is found, discontinue use.
•
Use only those repair parts called out in the parts list in this document. Items found in the parts
list have been carefully tested and selected.
Inspection
Before each use, an approved inspector must inspect the lift for bends, cracks, dents, elongated holes, or
missing hardware. If damage is found, discontinue use.
Repair
When repairing the lift, use only those repair parts called out in the parts list in this document. Items found
in the parts list have been carefully tested and selected.
Disposal
At the end of the useful life of the lift, dispose of the components according to all state, federal, and local
regulations.
Preventive Maintenance
NOTE: 1 cycle = 1 complete raising and lowering of the lift platform.
Every 300 cycles or 6 months, whichever comes first:
A. Hydraulic Cylinder
1. Inspect for hydraulic fluid leaks.
●
Some oil accumulation on cylinder rod is normal and desired for proper function of the unit.
●
If fluid is escaping and puddling on the floor, the cylinder requires servicing.
2. Without load applied to platform, raise and lower lift multiple times. If cylinder pulses, sticks, or
generally doesn't operate smoothly, unit needs servicing.
