Step 6 – Installation of the electric fence device
Correct installation is essential for proper, functional and safe working of your electric fence. The electric fence
device (A) should be placed near a power outlet and the fence, but always in a sheltered environment, such
as a shed or under a roof and always protected from direct weather.
Warning!
Do not connect the device to the power outlet yet!
Connecting the Minus Cable
1. Loosen the left (green) knob at the bottom of the electric fence device. This is the
button with the Earth symbol above it.
2. Remove one of the two metal rings behind the green button.
3. Now bend the stripped part of the ground cable (Y1) back halfway through 180
degrees as indicated in the adjacent picture.
4. Place the bent wire over the threads of the electric fence device and put the ring back.
5. Then turn the knob on the thread again and tighten the knob firmly (hand-tight).
Connecting the Plus cable
1. Strip the end of the ground cable (Y2) according to the instructions in chapter 5.
2. Now repeat the steps as indicated for the Minus cable, but now for the red button.
This is the button with the lightning symbol above it.
Warning sign
Is part of the fence on the street side or in another freely accessible public area?
In that case, place a supplied ‘warning sign’ (G) in a clearly visible place of your
fence. Use 2 small plastic cable connectors (not supplied) to do this.
Tip:
After completing all of the steps above, check the entire system one more time.
Step 7 – Switch on and test electrical installation
When all the above steps have been completed, you start the electrical system,
Insert the plug of the electric fence device into the power outlet (220/230 VAC). The light on the front of the
electric fence device will now illuminate, indicating that the device is working properly.
Warning!
There is now electricity on the fence.