background image

 

 

 

3E4465 Gallagher HBUS 8 Port Hub Installation Note | Edition 4 | January 2021 

Copyright © Gallagher Group Limited 

Page 7 

5

 

Approvals and standards 

FCC 

 

This device complies with part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) This device may not cause harmful interference, and (2) 

this device must accept any interference received, including interference that may 

cause undesired operation. 
Note:  Changes or modifications not expressly approved by Gallagher Limited could 

void the user's authority to operate this equipment. 
Note:  This equipment has been tested and found to comply with the limits for a Class 

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential installation.  

This equipment generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference 

to radio communications.  However, there is no guarantee that interference will not 

occur in a particular installation.  If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the 

following measures: 
•  Reorient or relocate the receiving antenna.  
•  Increase the separation between the equipment and receiver. 
•  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

•  Consult the dealer or an experienced radio/TV technician for help. 

 

This product complies with the environmental regulations for the Restriction of 

Hazardous Substances in electrical and electronic equipment (RoHS).  The RoHS 

directive prohibits the use of electronic equipment containing certain hazardous 

substances in the European Union. 

 

This symbol on the product or its packaging indicates that this product must not be 

disposed of with other waste.  Instead, it is your responsibility to dispose of your waste 

equipment by handing it over to a designated collection point for the recycling of 

waste electrical and electronic equipment.  The separate collection and recycling of 

your waste equipment at the time of disposal will help conserve natural resources and 

ensure that it is recycled in a manner that protects human health and the 

environment.  For more information about where you can drop off your waste 

equipment for recycling, please contact your local city recycling office or the dealer 

from whom you purchased the product. 

 

AS/NZS IEC 60839.11.1:2019 Grade 4, Class II 

 

EN50130-4 

EN55022 

 

 

          

 

 

 

Summary of Contents for C300698









Reviews: