ADP 4100 Printer
To use the cleaning card, follow these steps:
1. Power the Unit on.
2. Take the Unit off-line (press the ONLINE key).
3. Press the ENTER key to enter the menu system.
4. Press the UP/DOWN arrow key until the “Print Tests” menu
appears.
5. Press the ENTER key to access this menu.
6. Press the UP/DOWN arrow key until the “Cleaning Card” option
appears.
7. Press the ENTER key.
8. Tear open the pouch containing the cleaning card.
9. Insert the cleaning card into the front revalidation slot of the Unit.
The Unit will automatically move the cleaning card through the
encoder, print head, and exit path areas of the Unit.
10. Wait until all motors stop running before using the Unit, and allow
at least one minute for the cleaning solution to evaporate.
11. Press the ONLINE key and place the Unit back in the on-line
state.
Periodic Inspection
Every three months (more often in high-volume applications), inspect
the Unit for unusual wear or damage to components. The inspection
will take less than 10 minutes.
1. Carefully inspect the outer surfaces of the Unit’s
enclosure
for
signs of excessive internal heat buildup. Visual evidence of
excessive internal heat buildup may be confirmed by observation
of discoloration or warping of the covers surrounding the
electronic components.
2. Examine the Unit’s external and internal surfaces, ventilation slots,
transport mechanism, and exposed components for dust buildup.
All dust should be removed at least every three months to
maintain performance.
3. If cleaning is required, complete the recommended cleaning
procedures listed in the following sections.
ADP 4100 Printer
Installation and Operators Manual
, April 2007
25
