Galeo PC78MR-6, Operation & Maintenance Manual

Page: 240 / 295

.
MAINTENANCE
MAINTENANCE PROCEDURE
WASH WASHABLE FLOOR
With the washable floor, it is possible to flush out the dirt on the cab floor directly with water.
WARNING
When setting the machine at an angle, use strong blocks to stabilize the machine and be extremely careful when carrying out
the operation.
If the control levers are touched by mistake, the machine may suddenly move, and this may lead to a serious accident. Always
set the lock lever securely to the LOCK position before standing up from the operator's seat.
NOTICE
While cleaning the cab floor, take care so that the connector, air conditioner main body and filters may not be splashed with water.
Method of Washing
1. Set the machine at an angle.
For details, see "Method of Setting Machine at Angle (PAGE 4-46)"
2. Swing the upper structure slowly so that water drain holes (1)
in the cab floor are at a low position.
3. Lower the work equipment to the ground and set the machine
in a stable condition.
4. Set the lock lever to the LOCK position and stop the engine.
5. Remove the floor mat.
6. Remove cap (2).
7. Flush out the dirt on the floor directly with water through water
drain hole (1).
8. After completing the washing operation, install cap (2) and floor
mat.
4 - 45