MAINTENANCE
MAINTENANCE PROCEDURE
4-75
EVERY 5000 HOURS MAINTENANCE
4
Maintenance for every 10, 100, 250, 500, 1000 and 2000 hours service should be carried out at the same time.
CHANGE OIL IN HYDRAULIC TANK
4
WARNING
q
The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for
the temperature to go down before starting the work.
q
When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it.
q
Refill capacity: 360 liters (95.1 US gal)
q
Prepare a handle for socket wrench set
1. Swing the upper structure so that the drain plug under the
hydraulic tank will be between both tracks.
2. Retract the arm and bucket cylinders, then lower the boom
and put the teeth in contact with the ground.
3. Set the safety lock lever to the LOCK position and stop the
engine.
4. Remove the cap of oil filler (F) at the top of the hydraulic tank.
5. Set the container to catch the oil under the drain plug at the
bottom of the chassis. Remove drain plug (P1), then loosen
plug (P2) and drain the oil. After draining the oil, tighten drain
plugs (P1) and (P2).
Tightening torque: 68.6 ± 9.8 N
·
m (7 ± 1 kgf
·
m, 50 ± 7 lbft)
(A): Rear
Summary of Contents for PC600-7
